Energy metering, sub-metering and half-hourly consumption monitoring — set up at the BMS level, so waste and compliance gaps show up before the bill does.
Out-of-hours plant running, a hunting control loop, or schedules that were never updated after a change in building use.
Total consumption with no breakdown — making MEES/EPC reporting and tenant recharging guesswork.
Only monthly totals available, hiding the demand spikes and out-of-hours running that actually drive cost.
Meter points already exist on the head-end but were never configured to log, trend or alert.
Wire and configure meter points into the BMS head-end, broken down by system, floor or tenant.
Trend logs, consumption dashboards and scheduled reports built directly from existing BMS data points.
Consumption and sub-metering data structured to support MEES and EPC reporting requirements.
30-minute interval data with alarms on demand spikes or consumption outside expected schedules.
Compare schedules against actual consumption to find out-of-hours running and hunting control loops.
Consumption data structured and exported to support carbon reporting and ESG disclosure requirements.
Energyscoped sets up and maintains energy metering, sub-metering and consumption monitoring at the BMS level for commercial and industrial buildings across the UK, including MEES/EPC compliance reporting and energy waste diagnostics.
Usually out-of-hours plant running, a control loop hunting rather than settling, or schedules that were never updated after a change in building use. We trace the consumption data back to the cause.
Sub-metering breaks total building consumption down by system or tenant. It supports MEES and EPC reporting by showing where energy is actually used, which is often required for larger commercial buildings and multi-let sites.
Yes. Most existing BMS platforms already hold meter and consumption points — we configure the head-end to log, trend and report that data rather than installing a parallel system.
Cost depends on the number of meters, whether new sub-metering is needed, and the existing BMS platform. We provide a fixed quote after a site survey.
Yes. We configure energy monitoring and metering on Trend, Tridium/Niagara, Honeywell, Schneider EcoStruxure and Johnson Controls Metasys, regardless of who installed the original system.
Half-hourly data shows consumption in 30-minute blocks rather than a single monthly total, making it possible to spot out-of-hours running, demand spikes and equipment faults that a monthly bill would hide.
Yes. We compare BMS schedules against actual half-hourly consumption to find plant still running outside occupied hours, then correct the schedule or control strategy causing it.
We call you back the same working day.
Prefer to talk? Call 020 3900 0000